Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The range will depend on the module you use...and how much power you are putting in the Tx side..... if you need circuits you can check the following links...
Transmitters :: Electronic Circuits/Schematics Directory :: Next.gr
**broken link removed**
Hope the links help you...
Hey if you are from india then you can go for :+: Online TPS Shoppe - Buy Electronics and Robotics components - India, Techfest 2011 ,Kshitij 2011 competitions Free Stuff Atmel PIC microcontroller sensor LFR USB AVR 8051 Programmer STK 200/300 motor 433mhz transmitter Buy Price Rs Satisfaction G...
Specification is not only the pin structure but it also describes the limiting points of that ckt, how they can be operated, what are the features, design flow etc..Actually there are sooooo many things to be described...
Your question is quite confusing but I think as the frequency of output is exact half of the clock when i/p is 1 so it will depend on the logic level of the clock...you didn't mention whether the FF is a rising edge or falling edge triggered one...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
