Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello.
I measured my 2-port DUT on a network analyzer and saved the .s2p file.
Then I took the short, load, open, and thru data and saved it to a .s2p file.
How can I use my four calibration .s2p files to de-embed my DUT and get the s-parameters of my DUT?
I have Microwave Office and MATLAB...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
