Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Running NS2 in windows is very easy. Here is a step by step tutorial how to install it in Windows:
Ns2 Installation on Windows | paulson.in
I just did recently and I found it very useful
Running NS2 in windows is very easy. Here is a step by step tutorial how to install it in Windows:
Ns2 Installation on Windows | paulson.in
I just did recently and I found it very useful.
Hi
I recently inistalled it on Windows XP. It is working fine for me. You can try this forum:
Ns2 Installation on Windows | paulson.in
What I can understand from your email, you probably have basic problem of proper installtion.
Hope it helps.
2G and 3G both are commercial name coming from ETSI/3GPP. The major noticeable difference in 3G technology wise from 2G is over all change of system architecture, modulation scheme and overall network performance. 3G is some more step ahead of higher data rates than 2G which brings better...
ber ofdm
can you explain where exactly you need help? I think I saw this code. you have to get BER result. and then plot against the values corresponding to those.
help needed about GSM
For Quick Download :
ftp://ftp.3gpp.org/
Always look for "latest" folder. The Specs are now moved in Rel-8 recently.
Are you looking for any specific Spec?
download ebook ofdm nee prasad
"simulation and software radio for mobile communications" Hiroshi Harada and Ramjee Prasad...The book is available in this forum
I suggest reading about Space-time Block code. There is one paper written by Alamouti, in IEEE. That is available online. If you read about ST Block Code it will be easier to understand other stuffs.
**broken link removed** [check the reference section...read Alamouti's paper also Vahid...
Hi Atre,
Well basically what I did I reduced down my total output pin number from 64 to 32. It is working fine now. But I will try your way. But I think there might be some limitation somewhere. What I did was based on assumption and trial and error method...I found I have to be limit my design...
hi Semi,
I finished the work... I posted the way I found solution in another section of this board.
"I found the solution. When u write the boot command for SEULTRA u have to incresase the memory parameter. Say like "seultra -m=500 &" << allocates 500MB memory for ur database...."
Thank you for...
Re: Placement and Routing problem in Cadence Silicon ensembl
I found the solution. When u write the boot command for SEULTRA u have to incresase the memory parameter. Say like "seultra -m=500 &" << allocates 500MB memory for ur database.... :D
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
