Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Yes I did it in that way but doesn't works. I select the VIA1 and change the drill but nothing. I think is something wrong with the printing.
When I used OrCAD Layout 9 it worked, but with newer versions not.
Thanks for answering!
Hi everyone,
I am trying to print a board which has 0.2mm via drill holes, but when I print the top and bottom with the selection box Keep drill holes open checked the drills are bigger (0.8mm aprox.). I can not print them less than this value.
How can I fix it?
I am using OrCAD 16.2.0...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
