Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
the Chinese site did not help much. But I have now figured out what kind of filter I need to design. I need a filter with a common-mode choke that dampens the common mode noise. Then I also need a LC filter to suppress the differential noise from the LM2576 and also my internal DC/DC...
Hi,
have run into some problems. I need to design a power supply for 24V dc 1amp. The problem is that it needs to fulfill a lot of standards. The device that has the built in power supply needs to be classified for use on ships. I need to fulfill the following standards.
IEC 61000-4-4 Fast...
Hi,
thanks for the tip, got me searching in a new direction. The op amp solution is not really suitable for my application due to the space. But I found a circuit named MC33161. This is a universal voltage monitor. I am going to use this one. I was also in need of the big temperature range -40...
Hi,
I have product that have dual redundant power supply. But I would like to have a voltage OK led.
The power supply can take 7 to 50 VDC input voltage and gives out 5VDC. I now only have a led connected to the output of the power converter. But if the input voltage goes below 7VDC the led...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.