Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Yeah, the resistor is wrong, I will go and try to find one of these, I made the wrong conversion from Komh to omhs and now I have a good resource here
I will buy this one on Tuesday, public holidays here in Australia.
I have corrected my wires, now all GND are black.
I will update this...
Thanks again KlausST, yes you are 100% correct, I skipped that resistor as well, I have now done it, and using that new knowledge, I have check all the rest of the circuit and it seems now correct.
The only issue I have now is the Motor, it seems the motor is beeping only, not actually...
UPDATE:
I understand everyone's concerns on why a blower and why not an actual ventilator, I decided to continue this blower, the person I was building this for is safe, so for the ventilator comments please open another thread, I am interested in a ventilator as well!, I just want to finish...
Arduino is programmed, yes, compiled and uploaded, no issues here.
Yes, connected the motor, however the motor comes with 2 cables, the BLDC comes with 3, I am investigating.
My bad, I meant to say my Motor comes with 2 wires, the BLDC comes with 3.
The Materials I am following are here https://github.com/jcl5m1/ventilator
Under Materials, the Motor is a blower and the project seems to work with no problem connected to the BLDC, hence my confusion.
The circuit allowed me to power the arduino through the BLDC Speed controller, I am powering the BLDC with a 12v 5A power adaptor.
I hope the BLDC is powering the Arduino with what it requires. :/
Hi all, I have put together the complete circuit making sure the GND's are together, included the capacitor and the switch.
I only have one doubt about the MOTOR, the examples I see everywhere are motors with 3 cables, mine only comes with one, I think this is called BRUSHED.
So I am unsure...
Hi all,
I am very new to electronics, I am building a ventilator made by someone here https://github.com/jcl5m1/ventilator
The reason I am building this is that I have someone very closer who may need a ventilator if infected before the vaccine for COVID-19 is available to all.
The Arduino...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.