Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi,
The device model in netlist does't match with in cmdfile,how can i modify the spice to match device model ?
There are some dummy mos in my layout ,but when i run it's lvs, i found the dummy mos was missing.how can i modify the cmdfile to recognise the dummy mos, ths!
who can give me some inf...
now ,i have resolved Q:3.
the answer is leSetFormSnapMode(\"diagonal\") 45
leSetFormSnapMode(\"orthogonal\") 90
leSetFormSnapMode(\"anyAngle\") any angles
i will try my best to settle the rests.
If you know please tell me the answer!
ths!
ok.
i'm sorroy, i need some layout editor as follows:
1. array cell
2. turn in horizontal and vertical when i copy and move
3. how could i do 45 and any angles path
4. logo
5. how can i set up "calibre" on the menu banner
ths,my email=bj.ic@hotmail.com
Added after 5 hours 43 minutes:
now ,i...
hi,
You can settle it in virtuoso layout editor with skill.
But i'm sorroy i don't know how to do.
remit to programmer in your Depart.
Best regards.
Added after 21 seconds:
hi,
You can settle it in virtuoso layout editor with skill.
But i'm sorroy i don't know how to do.
remit to programmer...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.