Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello experts,
I am working on transmitting ECG on Zigbee. please can anyone help with a complete PQRST ECG data with just about 20 samples and less than 80bytes. A constraint i have is that the modules will only accommodate about 84bytes of data at a time.
Many Thanks
hi all,
Please i need to know if the ECG data obtainable on physionet.org contains noise, or has been filtered....
I downloaded an ECG file from the PTB Diagnostic ECG database(ptdb), and am trying to plot it using
Visual Basic, but my plot does not look like the one on the website...please...
Dear friends,
Please i need a Matlab GUI (and code) to analyse and display graphically the ECG and Temp signals received via my zigbee transceiver.
Thanks
Hello Deepu,
can you help me with your code and GUI please. i need a GUI that can analyse and plot ECG and Temp values, gotten via the xbee wireless link. Thanks
Dear all,
My project seeks to demonstrate the usage/merits of the Zigbee Protocol in signal tx, so i need something that is strictly Zigbee
I already bought a XBee ZB S2 ZigBee Module for my project, but due to a difficulty or its reduced compatibilty with MicroChip PIC's, i am...
hi bmb_10,
thanks. itz here:
//////// Standard Header file for the PIC16F877 device ////////////////
#device 16F877.h
//////// Program memory: 8192x14 Data RAM: 367 Stack: 8
//////// I/O: 33 Analog Pins: 8
//////// Data EEPROM: 256
//////// C Scratch area: 77 ID Location: 2000
////////...
hello all,
After compiling this code;
#include "C:\Users\xyz1\Desktop\xyz_new\new tutorial.h"
#include<16F877.h>
#use delay(clock = 10000000)
#fuses HS,NOWDT
#use rs232(baud=9600,parity=N,xMIT=pin_C6,rcv=PIN_C7,stream=RS232,bits=8)
//the RS-232 port is set up...
Hi pal,
Permit me to join in the discussion.i compiled your code;
#include "C:\Users\xyz1\Desktop\xyz_new\lab tutorial.h"
#include <16F877A.h>
#device adc=16
#FUSES NOWDT //No Watch Dog Timer
#FUSES HS //High speed Osc(>4mhz for PCM/PCH) (>10mhz for PCD)
#FUSES NOBROWNOUT //No...
@ evrybody, thank you very much,
is there any other c compiler available that i can use to write simple programs that do not involve microcontroller. i observed that in using the ccs c compiler you have to select a particular microcontroller, and set some basic configurations. for instance, i...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.