Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Guys
I want to make dummy module for Canon camera battery (LP-E12) and provide power externally to camera but I can not find PIN OUT for battery.
There are four PADs on battery from which two are for thermister and two are for power but I can not confirm which one is which.
Please its...
Hi guys,
Recently I was looking at one of the PCB design and in master drawing designer had mentioned about IPC and UL standards(IPC-6012 Class 2, UL 796, IPC 4552, IPC-SM-840, ).
Now When I looked on google for those standards, I found it is related to PCB manufacturing.
Can some one...
Hi Guys,
Recently I was working with some agricultural project and I came to know that I have to implement ISO 11783 for certification.
If some one can guide me with difference between ISO 11783 and ISO 11898.
Thanks
Hi All,
Recently I was reading MiWi Mesh networking. As low power and high power Mesh network is looks like future big shot.
Regarding MiWi (from micro chip as it is $15 max) is it possible to interface with other than PIC micro?
Can I connect it with TI micro e.g. MSP430 or Sitara ?
Hi Guys,
After finishing schematic, when I check DRC it gives me following error,
'
Checking Misleading Tap connection
ERROR(ORCAP-2207): Check Bus width mismatch
'
Although It doesn't affect design later on but still its an error.
Please help me to understand why OrCAD gives me that error.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.