Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
free freescale hs12 compiler
I'm a beginner.
I' didn't wrote C code for uControllers before.
I have some questions, if you have some time, please help me:
i want to built a little project: i want to programm this MC68HC908BD48 for a standard CRT monitor. I need to interface it with TDA9113...
Re: about common emitter
Hmm, let's see:
Rin=(R1||R2)||hie , where hie is the impedance between base and emitor in common emitor mode.
hie=β/gm, where gm=Ic/Vth, where Vth=K*T/q.
gm=40*Ic ( mA/V ) @ 25 Celsius ( ambient temperature )
The voltage gain is about Av = Vo/Vi= -gm*Rc, where Rc is...
i think both solutions create problems.
1. we can't make a ground with the soundboard, because we'll short-circuit the
-12V ( ground ) coil.
i've tested it with a big primary coil of a transformer, and 10.000uF capacitors, and it doesn't work when the supply current of the amplifier is low...
yes, the battery is dead in almost 95% of cases.
you can try to fix it by charging it at a low current for one or 2 days,
after that please use it until a complete discharge.
repeat the process for 4-5 times.
it should work, but the method is not guranteed.
regards,
baza
agilent oscilloscope power problem
Almost sure a supply problem.
Check the power source.
Also please connect an analog multimeter between high capacitors leads, to find if you have some short-circuit.
If you repair the power supply, you should have something on the screen.
Also check the HV...
Re: about common emitter
You'll choose Icq in function of your application purpose.
Work at low signal ( the variable component should be 10% or less of the continous application ).
It depends where you'll use BC547 ( amplifier, mixer, SMPS etc etc )
uc3842 spice
Hi,
I want to simulate SMPS with UC3842 ( KA3842, TL3842 ),
Can anyone help with a library for Pspice, Orcad 9.2?
Also i need a good library, which should contain some chopper transformers, to use them in the simulations.
Thanks! :P
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.