Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by bassplayer142

  1. B

    Error correcting packet protocol source code

    Does anyone have any recommendations for some free and quick source code for a packet interface. I'm looking for something along the lines of start byte, n-byte length, n-bytes of data, checksum, end byte. I want reliable communication that will drop packets and/or not get hung up on code...
  2. B

    PSoC Frequency Measurment

    Hi everyone. I'm trying to determine the frequency of a incoming signal at roughly 7KHz. This signal is correctly identified using a scope and is at correct logic levels. I am using the 16bit Tachometer digital block which adds a second interrupt. It is basically a 16 bit timer with the...
  3. B

    Is the ADS1022 Oscilloscope any good?

    I stumbled upon this o-scope in my search for an inexpensive oscilloscope to buy. I have researched all kinds of important factors such as bandwidth, sampling rate, vertical gain and resolution,etc... Before I go out and buy something without thinking I figured some people here who have used...
  4. B

    dsPIC30f4011 with MCP4922 DAC problem

    I am trying to connect this digital to analog converter to the micro-controller with a small issue. First off, I the MCP4922 has 2 seperate 12 bit channels and the first one I send data to works while the other way stays near 0 volts. I have played with the CKE and CKP values which change...
  5. B

    dspic30f4011 input capture problem

    I am trying to calculate the frequency of an incoming signal on the dspic30f4011 micro. I have setup a functioning pwm signal to test the incoming signal on. I believe my code is picking up the difference between the time captures of the signal, but I'm not sure how to calculate the frequency...
  6. B

    laser spirograph questions

    I am going to build a laser spyrograph toy that can be seen here. **broken link removed** I actually have quite a few questions so bear with me. thanks First of all, is there a difference between the three lined schematic symbol that appears (I think as ground) and the one with only two...

Part and Inventory Search

Back
Top