Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hfss calculate odd mode impedance
oh,azulykit
the main problem is I cannot use HFSS to get the even-mode and odd-mode impedance and S-parameters I wanted after trying many times,so I am undecided about my model's setup.
I need some more details for designing in HFSS ..
regards
Added after...
transmission line even mode odd mode
Hi ,everyone
using hfss,how to set even- and odd-mode excitation for coupled microstrip lines?
looking forward to your replies!
babyang
Hi,ali110
yes,i can draw any shaped transmission lines i want,is it the same as uniform transmission line while defining ports,such as terminals, reference impedance?
Is there any details i should pay attention to while simulating nonuniform transmission lines?
define ferrite
Hi,all
I am an HFSS beginning learner,A question puzzled me when i reading about Ansoft HFSS-Material Manager about Ferrite Materials and Ports,as follows:
When designing a problem containing ferrite materials and ports, do not arrange the port so that it touches the ferrite...
I am learning hfss,unfortunately,there is no example about nonuniform trasmission lines like taper or other types simulation.Who can give me some advice?
Is there any other software used to calculate nonuniform trasmission lines?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.