Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I just bought a "Babel Buster BB2-6040 Mod-bus to ZigBee Gateway" (**broken link removed**) module. I am trying to integrate my Zigbee board (https://www.ti.com/tool/smartrf06ebk) with BB2-6040 Mod-bus to ZigBee Gateway but its not happening.
Is anyone using this gateway. I am not able...
hi,
I need to know the basics about the usb communication between pc and micro controller. I was able to establish the usb communication. Micro controller used is pic18f4550. The device is connected to pc as hid device.
I need to know the following topics,
what happens when a usb device is...
hai,
i am designing a quiz master module to conduct quiz. I have completed a wired module. Now i need to move on to wireless.
As the local rf modules(433.92Mhz) allow only one transmittor at a time. I have decided to make one using nordic rf2401 by setting different frequency for each...
hey i'm new to wireless ...
I just need to send data from a pair of transmiters to a pair of recievers simultaneously. Since the same frequency is blocking me.... I decided to go for seprarate frequency for each pairs...
can i adjust the frequency of the tranciever via coding or any hardware...
i need to play a recorded file to each subscriber. Also i need to set separate timings for each call. I think it would be better to do it in the server. can i go for that. Also different files should be played on different days.
how does the mobile operator make recorded calls to a mobile?
Hi all,
I am doing a project for a rotary club. Their requirement is to inform the club members about the meeting on specific days. So i decided to make a recorded call to each member through a server.
I have no much idea about the procedures. Can i do it succesfully. Kindly give...
ya, there is a bit to enable oscillation. And it is enabled. But, as i said before,it oscillates while connected to vcc......while disconnected from vcc, it just act as eeeprom just saving the previous time.
hi all,
I have sucessfully interfaced ds1307 with pic16f877a and is working fine. But it only starts its oscillation when in vcc only. When i disconnect the vcc ,it stops the oscillation and simply store the previous date.
can anyone suggest me a solutionb for it.
hai thank u all for ur valuable time and ideas......
max232 salved my problem and the steream i get was ascii......
can i interface 2 pic without max232
hi all,
i have succesfully interfaced the pc with my pic microcontroller 16f877a. But i don,t get the data correctly fpom the pc.
First off all, may i mention, i didn't go for max232. Can any one mention in which format the data is sent from pc--hex or ascii?..
i try to find...
hey,
can u please mention how many messages can be stored in apr6016. I checked the datasheet but it was a vain.
I need to store 40 messages each of 15 sec duration....R can anyone please suggest me an ic which satisfy my requirement...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
