Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Does anyone have access to the service manual (level 3) or schematics for a Motorola XT912 (or xt910 which is the GSM version). They were marketed as the Droid Razr (Maxx). I believe burned out the usb driver and would like to attempt a repair. Thanks
I have access to a few LG 12.1" LCD screens and was interested in interfacing them to either a microcontroller or single board computer. My problem is that the lcd panels dont have a driver or anything on them just the bare interface connector. I searched for driver chip/boards related to the...
the term PPM is parts per million, and is a way of measuing small concentrations.
As for calibration, they talk about test chambers in the PDF's which im assuming release a known concentration. I saw a similar setup for a helium detector calibrator which was a small tank, with a tiny orifice...
I am interested in purchasing the board listed below (or a very similar one) for use in a current project. Upon reading the data sheets I discovered that It is limited in the following ways
Velocity 1852 km/h (514 m/sec.) (limited by US and Canadian export laws)
Acceleration 4 Gs (39.2 m/sec.2...
gyroscope schematic
I'm not sure if you are looking for a mechanical version, if so im no help :)
But for a really cheap do-it-yourself version you could take two accelerometers a known distance apart, and integrate to get your angular velocity, and again to get position. However drift becomes...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.