Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Here, initially i designed a SOC using QSYS system integrator and exported to Nios II Eclipse. Their i have written a C code and now wanted to simulate my SOC using Modelsim.
The values printed in the console are because i have kept them in PRINTF in c code and since the soc is designed it is...
Yeah, I have added the signals into my window and started simulation...
As shown in the screenshot in the terminal window i have the results appeared as #123402 ,#11001011...and the added output.
But the same data iam not able to see at the waveforms window and instead im getting some...
Iam using Nios II Eclipse and their i have written the two data inputs required for my simulation and exported to modelsim.
But in the waveform window i was not able to see the data, but surprisingly it is visible on terminal window. The result is also appearing correctly in terminal window...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
