Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Question with installation of Cadence IC 5033 on Linux R
for your installation, you need six cds, 3 bases and 3 isr (or other type of fix), unless you just want to install base only, in such case, only 3 bases cd arerequied, if you start your installation from isr, then you need all these 6...
could not set up softload
Ok, I just installed it on Redhat AS 3, then could you give me detail instruction on how to configure so as to get it run? Thanks.
Added after 22 minutes:
by the way, I need ICFB only.
cadence ic
I have successfully installed cadence ic 5141 (3cd of base and 3 cd of isr) on redhat 9, but do not know what to do next, i do not know how to set enviroment and set license, even though there is tons of discussion here, I still ge stuck. Could anybody provide detail instructions on...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.