Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
thank you so much sir,, if you think there is something else which can help me in this circuit or in this field too..plz guide me... now i m very much clear and trying to simulate it in multisim and then will shift to ADS for complete transmitter receiver architecture.
best regards
dear sir, u mean it's low pass filter with cutoff freq 1/2*pi*r1*c2 ? is it?
suppose if we ignore diode and there is a sinusoidal voltage source across C1..what will happen?
thnx and best regards
sir , this is a passive receiver circuit, there are two antennas instead of voltage source. but when signal will strike on antennas, it will induce voltage. therefore just to model that voltage i have placed voltage sources here. my purpose is just to find out that how i can calculate the values...
sir this is an extra task just for learning purpose..i have to analyze it therefore the information is not clear, i have to perform a rough sketch how i can analyze such kind of circuits. how i can find the filter types, how i can roughly estimate the values through frequency or frequency...
thnx alot sir
actually i m student in RF field and it is my first task..so i don't have much knowledge...at the output of this circuit another circuit is attached but my task is only to find out the signal at this point.
it is basically a receiver, as i told earlier, that receives reflected...
thnx sir,
it is receiver circuit that will receive reflected EM waves at around 400 MHz. i m testing at different frequencies just to check the behavior but unable to find out the purpose of RC network. if it is pi filter what is the purpose of C1? using which formula i can testify the above...
hello all,
attached is a file in which there are two inputs (having phase difference) across the diode. after that there is a series RC network and the output is across C2 (output labeled). what is the purpose of this RC network in this circuit.. whether it is filter or impedance matcher or...
hello,
i have downloaded a library of hittite components from the following link:
https://www.hittite.com/support/ecomponents-library.html
now i m not able to add this library into Genesys..please guide me how i can add this library to genesys...
thnxxx....
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
