Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hey
i am using atmega32 to drive two DC motor(connected in parallel) forward and backward.
please tell about the interfacing circuit and IC needed to drive the two DC motors connected in parallell.
my PWM duty cycle is 10% for forward motion and 5% for reverse motion.
please help.....
a voice tag is entered via the microphone to the PC.In the PC matlab regonizes the speech and compares with previously saved samples.after the comparison the compared voice tag is converted to text {in matlab enviornment} and text is transmitted to a wireless transciever module for further...
sir
what is the most efficient programming language for 8 bit,16 bit,32 bit micro controllers?
and which real time OS is most efficient for 32 bit micro controllers?
thank you
i have used atmega8 mcu for my digital stopwatch application . and i programmed the IC with a C code using Winavr compiler. then my stopwatch is showing minutes and hours -but it should show seconds and minutes.
i have used atmega8 micro with a crystal of 16Mhz.
please help
thanks
how to measure the power spectral density of a recieved waveform?
is it possible to do taht in this way?
..by measuring wave voltage then using a micro controller-pre programmed with an empirical relation- to find the frequency of the received waveform and then using a DSP to calculate the PSD...
please help with project of atmeL AVR based digital clock...
i am having trouble with this...please help with the detail circuit diagram of atmel atmega 8 based digital clock........
thanks
if i want to program a microcontroller PIC and i am using MPLAB IDE on my pc then what are the hardware/connections required to connect the PIC microcontroller to my PC for programming.And then after my device based on microcontroller is ready and i want to control it using my PC then what...
is it necessary to learn assembly language for microcontroller programming.
Please tell some sources for learning the assembly lang...
What are the software and hardware requirements for programming a microcontroller in assembly lang?
do different architectures have different assembly language...
Re: embeded systems
thnx.i want to program avr usin Ansi c.could you please share the differences between the c which we use for the desktop applications and in case of microcontrollers?
Also please tell about the sources of the assembly tutorials and c tutorials for the mc...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.