Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I found an IPM (intelligent power module) for my application, but I need some information about how to controll it.
https://www.farnell.com/datasheets/93226.pdf
Anyone can help me ?
- - - Updated - - -
Thanks for your advices FvM. I found an IPM (intelligent power module) for inverter. I...
Maybe it's better to use IGBTs and their gate drivers instead of MOSFETs. I'm planning to design a 5 kW inverter which has tunable input voltage by boost converter. As you say, I need some calculations for boost converter switching freq. and inductance value...I have to decide which IGBT and...
Here is the boost converter control signal : (Duty Cycle =%90 1us off 9 us on, Freq= 100kHz)
So, what kind of gate driver sould I use inorder to turn fully on the mosfets?
- - - Updated - - -
Thanks for gate driver advice.I connected an IR2101 to circuit. I turned inverter full bridge to...
Thanks for your quick reply BradtheRad,
Answers:
*When I reduce the R2 value, nothing has changed. Even when I make open circuit, the voltage doesn't change on boost converter and inverter output.
*Here are inverter triggering voltages:
Hi friends.
I have trouble with my boost converter+inverter design. My boost converter is work proper itself but when I try to connect a full bridge inverter to output of the converter, converter output voltage dramatically drops down. Actually, I'm trying to have 220Vrms AC voltage from...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
