Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello;
The port is inside the structure; as i have understood, you have to use lumped port, but not wave port, to excite the 3D model.
Added after 58 minutes:
Hi, seira;
Have you ever checked the setting of the material "segment 6" as the dielectric material?? I found that you set it...
Dear RH1101;
I appreciate your advice very much.
It is helpful for me, and I believe that your advice is helpful for all of the engineers in any specific field. Wish many people could see it.
best regards,
ap001
soc and sop
Hi Dear Friends;
I am looking for a new job as an RF engineer. I got two opportunities: one is to be an RF transceiver IC desiging engineer and the other is to be an RF LTCC (low temperature co-fired ceramic) module designing engineer. SOC seems the main trend for the whole IC...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.