Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
Is it possible for RFID tags to have an excitation coil to supply the required voltage to the RFID transponder and then use other RFID readers to get the data from the RFID transponder ?
how is this done in term of design and in term of frequencies ?
Thank you
Hey there,
In CST i read that the frequency domain solver is better used with structure having dimensions less than the wavelength. So i had my sturcture and got good results using Frequency domain solver. I tried to simulate the same structure with Transient solver but results were so bad...
Hello,
I am woking on my project which is a positionning system using RFID tags at 13.56 Mhz
My task now is to simulate a system having 1 RFID transponder and 4 RFID readers and to get the induced voltage in each of the readers. and depending on the voltage induced in each reader the position...
Hello,
I am having my bachelor thesis on RFID. i need to simulate a RFID 13.56 tag using CST microwave studio.
Can anyone help me in that?
Attached is my simulation trial, but unfortenately it doesn't give any good results.
So if you have any idea why is that?
For any helping material please...
hello,
i am new to RFIDs
and my thesis is to do an positionning system using RFIDs.. i need to simulate this system on CST MWS...
Anyone can give me some hints? thnak u
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.