Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I would like to clarify the length of the waveguide is just 1000 mm, there is still a gap in the waveguide in the form of a dumbbell, where the width is 0.5 mm, the radius is 2.5 mm, it is located in the middle of the narrow wall of the waveguide
Hello.
When I run a simulation for a simple rectangular waveguide in a frequency range that includes the cutoff frequency, I should see a change in the S-parameters that show the cutoff behavior of the wave stream. But S11 does not show what should come out according to calculations.The cutoff...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.