Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I want to find out the transmission code used in LG air conditioner remote control. The module no. of the remote control is 6711A90042U.
Can some one shed some light on this issue.
Thnx,
Amila
iso 15693 amplifier
Hi!
Thanx a lot for the reply. Currently i only have SMD components(specially inductors) of the given value. So i taught of building a PCB for this. Are there any special points i need to look into in designing this PCB( any RF issues)?
Thanx again.
Amila
13.56mhz amplifier
HI!
I'm designing a RFID reader using ISO15693 protocol at 13.56MHz using TI S4100 module. This reader unit would have an output power of about 200mW. I'm using a 50 ohm matched loop antenna with 50cmX50cm dimensions. Up to now a range of about 25-30cm was achieved.
I want to...
mlx90121 based reader
Hi!
Thnx for the reply.
Well the circuit is built according to the given schematic. And we can see that the transmission is happening. We are using a PIC16F877.
May b the problem is with the implementation of ISO15693 protocol by us. We wrote the code for an inventory...
mlx90121
I'm using a MLX 90121 RFID reader and using ISO15693 standard. I have built the reference circuit given in the device data sheet and it s outputting decent amount of power. I have written the firmware for the chip implementing the standard for an Inventory request.
The problem is im...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
