Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
this a picture of coupler:
Input and output ports are selected microstrip port. I want to add chip resistor between the specified sections by arrow, but I can't use transmission lines and loads in FEKO. the file is attached.
Hi, all
I want to simulate chip resistor in FEKO, or HFSS between two parts in a wilkinson power divider, then I found loads between ports in FEKO but the problem is that part (which I want to apply chip resistor to it) is not port and I can't add port in middle of model.
How do I do that...
Hi, all
I want to simulate chip resistor in FEKO, or HFSS between two parts in a wilkinson power divider, then I found loads between ports in Feko but the problem is that part (which I want to apply chip resistor to it) is not port and I can't add port in middle of model.
How do I do that?
thank
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.