Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello
can anyone help me
I want to understand something about blocking in texas instruments datasheet c1101
I this attached file , in the table it talk about blocking @ 2 Mhz and 10 mhz has values -50 and -40 dbm then in graph it show selectivity
is this graph show the attenution for these...
what I asked you before was only in simulation but now I am going to build it in real and try it
---------- Post added at 20:52 ---------- Previous post was at 20:25 ----------
Ok thanks very much tahmid i tried in real and work but why it doesnt work in proteus
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.