Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i am using Traccar open source
the following AT commands are Valid to connect over TCP but i don't find any response at traccar server????
AT
ok
AT+CPIN?
ok
AT+CGACT?
+CGACT: 1,0
+CGACT: 2,0
+CGACT: 3,0
AT+CIPSTATUS
STATE:IP INITIAL
AT+CIPMUX=0
OK...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
