Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
https://ww1.microchip.com/downloads/en/devicedoc/39582b.pdf
this is the datasheet
and it says that pin 1 is the mclr , and this ia what i did .
and about the veelman !
i Wondering what is the problem , just like i said the components are good , but the red light doesnt work , unless i touch...
yes its mclr !! isn't the right way ??
the programme wich included with it can test every thing in the circuit then show the result as LED light up .
and i have multimeter , and checked the circuit with it , no problem ! every thing works OK !
thank you :)
i will try .
---------- Post added at 09:47 ---------- Previous post was at 09:37 ----------
thank you , but no its in the right way but the picture is so bad .
and my vellman is K8076 .
its problem the red light is not lighting , but if i touch the transistor or resistor...
hi every body
first , i am an engineering student , and i'm beginner in these stuff .
i bought a velleman programmer , but there is something wrong in it , so i just need
to build my own programer right now , just for learning .
this is what i did.
MCLR----TxD ::: there is a white wire...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
