Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Googling I found this power supply feeds Olympus Iplex SX II R videoscope inspection device :unsure:. If anyone is familiar may be able to help. :cry:
thx
I didn't realized how eBay links got into my post up there. I am trying to edit and remove them but it says I don't have permission to edit my above post. Am I missing something?
Hello. I have a AWJ-6C172S power supply fans not spinning when I connect power cord. There is no on/off switch on the power supply. It seems there should be a Triger (turn on) pin like computer power supply. I have attached pictures of the power supply front and rear and control connector. Other...
I have a normal oscilloscope but it does not have capabilities for UART tracking. I might be able to borrow one but still I don't have enough expertise to do tracking unless I see no way except using this tracking method which in this case I have to find an expert person and required equipment...
@ KlausST
I forgot to tell that this log is recorded when I click on "download" which is intentionally included inside the device pc software for downloading these information for using these information for calibration purpose but there is no way to save these information into a file otherwise...
@ KlausST
I am sure data are read from device. I know what are the data and are all inside the device. I am 100 percent sure data have read from inside device SBC.
@FvM
Picture of the two types of SBC inside the two different models of the device are attached. I can take higher resolution pics...
I don't have any information about this SBC. I tried to get some info from TTM but no reply from them. Following is a part of the serial port monitor log. There are read and write commands along with communication parameters commands which shows it may be possible to read, change and write back...
No. I don't want to reverse engineer this board. I want to save these information into a file for a backup. When device needs repair and replacing some chips then I can reload these info to the device and make it to work. Device is old and vendor no longer supports its repair.
Device software...
Some says there might be no files or directories. Still it is OK if I can read the code inside SBC and inspect it directly and write it back. Is this possible? If so how? Any software in this regard to help?
Hello, We are using a device with a single board computer inside. It has a usb and rs232 ports for its PC software to communicate with the device for data transfer. I want to browse files and directories inside this computer. I tried windows xp "ActiveSync" and windows 7 and 10 "windows device...
W
What is the highest temperature range for 2 part epoxy resins?
Attached is a photo of the factory resin used for sealing (Brown color). I am looking for the same or close resin to repair the leak.
Detector pins voltage is about 10 kv and sometimes for cleaning and re-evacuuating the detector...
Epoxy resins are used for high voltage power insolators (see attached photo). Anyone can name a few 2-part epoxy resins which are suitable for this purpose? I want to repair a detector and I need to use epoxy resins which can stand high voltage (10 kv) and high tempreature (250 degC).
Detector...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
