Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
For the following spec which converter topology is preferred?
Input 48-72V (DC)
Output 12V (DC)
Output Current 50A
Two-switch forward converter or Push-Pull Converter which topology is better in terms of efficiency?
Regards!
Thanks for reply.
I am using stm32F0 (12bit ADC) series MCU. The the supply voltage of LM358 is 5V. I am measuring lows side current.
How to calculate the error introduced by input offset voltage and what it offset balancing or cancellation? Suppose if the OPA has 2mV to 7mV input offset...
Thanks for reply
Op-amp power supply 5V
frequency range 50KHz
output voltage range 0-3.3V can be 0.2-3V
Please help to find suitable OPA device.
I am trying to build low side current sensor.
Regards
Hi
I am looking for a DC current sense circuit which can measure 10-30A current with 0.5A accuracy. The shunt is 1mR. Which configuration of op-amp is suitable for this application? I want to use LM358.
Best regards
Hi,
How over load and short circuit works in DC/AC inverters? Is is handled in software or hardware? How mosfets are protected during short circuit in AC inverter stage?
Regards!
Hi,
What is range bin in FMCW and binary coded pulse radar? How its related to target distance specially in phase coded pulse radar utilizing corelator or matched filter?
Regards!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.