Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i tried the circuit today but some thing very strange appeared
as the two upper mosfets worked although i connected HIN and LIN of the reverse direction to ground and LIN of forward direction to Vdd and applied my PWM signal to the HIN of forward direction transistor
note : i'm sure my...
as the motor is 12 V so i can use 15 as there will be voltage drop on Vds of both transistors or may be 20 will be better
but afraid the motor git bamped
- - - Updated - - -
also what bootstrap capacitors shall i use to work on 10Khz freq
and i've 1N4148 diode shall i use it in the bootstrap...
firstly i'm using different Transistor as i'm using IRF 1405 n-MOS transistor
and the motor that'm working on is 12v DC
so i think value of resistors and capacitors shall be changed also ?
value of load supply what shall i use ?
hi all
i read so many threats here about that topic i'm using IR2110 to drive IRF1405 n-mos channel transistor
i want to know what's value of Vdd ,Vcc , capacitors and resistors shall i use to drive 12v motor
thanks in advance :)
here is it my schematic i'll use .
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
