Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
This is just an intermediate part. I will add another TL where the load is then I'll match it with a proper load. But before that i need to validate my theory.
No, there's no particular reason for using that. I needed to match the ports and usually I use this port and haven't run into any problems yet. What other port can I use?
I've tried that but it still shows the error. The only workaround I can think of is if I use a value close to zero, i.e. 0.00000000001, but that changes the desired result for frequencies higher than 1GHz.
Hello,
I am getting the following error while simulating a RF Crossover ckt:
"Error detected by hpeesofsim during netlist flattening.
`TermG1': Value of `Z' should be positive."
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.