Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by a.abbas

  1. A

    Flicker noise in mos and bjt

    dear all why is flicker noise lower in bjt then in mos, and lower in pmos than in nmos ? dows anyone have a paper or ebook describing this issue in details...? thank you very much 8)
  2. A

    ADS momentum differential inductor

    ads momentum Dear all i'm using ADS to simulate spiral inductors using momentum simulation... the result is always in s parameters. Is there a methos to get result in z parameters (to extract inductance, series resistance, and capacitance) ? thank you all... :)
  3. A

    Matlab mfile needed: s2z.m and s2y.m

    Dear all does anyone have Matlab's RF toolbox...? i need the file s2z.m which conversts s parameters to z parameters or s2y.m which converts s parameters to y parameters..... thank you all :)
  4. A

    who can tell me how can i get vco specifications for 802.11b

    Re: who can tell me how can i get vco specifications for 802 Dear pigkiller check this link of GetIEEE802 program where u can find almost all IEEE802 standards for free... but not always complete...! **broken link removed** I worked a lot in this point ( finding VCO specifications based on...
  5. A

    Design kits in @ds agilent

    yes exactly.. this is how to install the design kit.... but how to get the TSMC design kit or at least its technology files? thank you
  6. A

    Design kits in @ds agilent

    dear all i want to use TSMC035 technology with @ds. How to get the TSMC design kit to add to @ds design kits thank you
  7. A

    How to get the substrate capacitance for any process?

    substrate capacitance calculate Dear all how to get the substrate capacitance for any process (for e.g TSMC035). i.e. what parameters are used to calculate the substrate capacitance
  8. A

    How to use TSMC 0.18u inductor for CMOS LC VCO design?

    Re: TSMC 0.18u inductor- VCO i attached the paper for u in my last post. it's name is "Large-Signal Analysis of MOS Varactors in CMOS -Gm LC VCOs" good luck :)
  9. A

    tail current's action in LC VCO?

    If no current source is used ,the output oscillation swings between -Vdd and Vdd. If a current source is added the oscillation amplitude will be equal to IbiasXRtank (for IbiasXRtank<Vdd) and Vdd elsewhere. Thus output amplitude can be controlled better and thus improving VCO linearity is...
  10. A

    Why Phase Noise in CMOS LCtank VCO is better than the Ring?

    Re: Why Phase Noise in CMOS LCtank VCO is better than the Ri check section V-B in this paper and read the answer... :)
See more

Part and Inventory Search

Back
Top