Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Endcap cells are inserted to fullfill well tie off specifications for the cell rows. Endcaps dont have signal connectivity. They only have connectivity to power and ground distribution in the design. Endcaps have a fixed attribute and cannot be moved by optimization steps. Endcaps are placed at the end of cell rows and handle end of row well tie off requirement.
End Cap is used in PNR , Routing will not be done after End Cap.
They are placed in each row.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
