Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

why we need clock transtion(edge triggering) for flip-flop

which tool is monstly used for ent-to-end product

  • cadence

    Votes: 0 0.0%
  • synopsys

    Votes: 0 0.0%

  • Total voters
    0
Status
Not open for further replies.

venkatesankalidass

Junior Member level 3
Junior Member level 3
Joined
Jun 14, 2007
Messages
30
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Activity points
1,469
why we always apply trigger to flip flops

hello guys ,
why we need clock edge transtion ( either fall or rise ) for design of flip-flop
 

triggering of flip flop

sequential circuits need to synchronous... sine async ckt's have quite a number of problems like rece conditions sync ckts are preffered over them... for this synchronous operation edge-triggering is used...
 
triggering of flip-flop

this is the basic difference between a flip flop and a latch.

latches are level sensitive and flip flops are edge sensitive.

This makes the contents to be stable for entire clock pulse in flip flops

Corect me if i am wrong
 
triggering of flip-flops

synchronous at the same time ,all the flip-flop will be triged
 
why we need clocks?

hi,l have used cadence tool,but used synopsys. l will try
 
whats the need of clock pulse in flip-flop

Hi,

If we are not using the edges, whenever the input value changes output also change accrdingly. Because of this we will get erroneous values before settling in actual value. It will make unnecessary switching and power loss. So we are narrowing the sampling window and allowing the input stable. That's why we are using edges.

Regards,
Kanags
 
triggering flip flop

First we need some cell to keep data. That means we need more than combinabtion logic.
I think use edge maybe the only way to capture data, even for latch.
 
triggering of of flipflop

Dear dude,

To store data we must edge trigger, either on positive edge or neative.

so only it will be understandable what data has to stored during that particular edge. mainly to synchronous data and clock to get data stored

if it level senstive it just passes the data from i/p to o/p till it reamins high.

Santu
 
why we need clocks

If we don't use DFF to latch data, we can't know the data process time.
In out application, we always do some math calculation or timing control.
If we don't use timing aspect in our design, it is always problem to real result.
 

why we need clock

We need it b'coz otherwise it will act as an latch
We have to consider even the setup time also
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top