Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
There are essential two methods of programming the FLASH based PICs using a programmer, High Voltage Programming (HVP) and Low Voltage Programming (LVP).
The most common method, used by PICkit and ICD programmers, is the HVP method.
HVP normally requires access to three pins MCLR (Vpp), Programming Clock (PGC) and Programming Data (PGD) pins.
What the actual pin numbers are depend on the specific device.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.