Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
If you just use it for MW circuit design, a general P4 processor is enough.
When i use MWS to design MS circuit, The most time spended thing is the optimose process!
I would use the IBM PowerPC 970fx. It's the fastes personal computer processor in the wrold and it uses less power and generates less heat than earlier models. Take a look at the fact sheet attached.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
