Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

what's common centroid?

Status
Not open for further replies.

egg

Member level 2
Joined
Sep 5, 2009
Messages
52
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,604
who can tell me what's common centroid or which book I can find the defination of common centroid?

Added after 2 minutes:

ABBA AABB ABAB
BAAB BBAA BABA

for the 3 plan, which is common centroid? why?
 

those three are all common-centroid.
A good book is "the art of analog layout" by Allan Hastings.
 

JoannesPaulus said:
those three are all common-centroid.
A good book is "the art of analog layout" by Allan Hastings.

Hi, I could not find it from this book, could you tell me concretelty?
 

The term is explained in most analog design text books, e.g. Razavi, Design of Analog CMOS IC or Gray, Meyer et al,
Analysis and Design .... You'll even find it mentioned at wikipedia. Your convenient kind of reading can't be
expected to result in profound knowledge.
 

Alan Hastings: The Art of Analog Layout

egg said:
JoannesPaulus said:
those three are all common-centroid.
A good book is "the art of analog layout" by Allan Hastings.
Hi, I could not find it from this book, could you tell me concretelty?
See CONTENTS page xii : Common-centroid Layout 231
 

In short Common centroid means if you see from the centre of matching geometry all devices should have same environment from all axis, which is commonly use to reduce the effect of linear process gradient or stress induced mismatch

Ya Alan Hasting is very gud book to refer, see on page no. 231-235; 330-331; 333; 435-439
 

egg said:
who can tell me what's common centroid or which book I can find the defination of common centroid?

Added after 2 minutes:

ABBA AABB ABAB
BAAB BBAA BABA

for the 3 plan, which is common centroid? why?

Al are common centroid: below are considerations:

case 1: best matching bcause : same surroudning and despersion is more so reducing random error.ofcaource ,drain parasitics will be more than 2 but will be matched.

case2 : good.. dispersion is less so less prefered than 1... less drain area.


case3: least prefered.
 

thinks all.

one more question to deepak242003,

why case3 is least prefered?
 

egg said:
thinks all.

one more question to deepak242003,

why case3 is least prefered?

More drain area as compared to other cases.. so more parasitics..

:)
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top