Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

What is possible Cause ?

Status
Not open for further replies.
A

aamiralikhoja

Member level 5
Joined
Aug 11, 2004
Messages
90
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
708
I am Using Pc Parallel Port In ECP mode. I am using Watcom "C" Compiler.

O.S is Dos. I am acquiring Data At 8kiloByte/Sec rate . Data is Valid.

when I increase Data rate (Strobe) to 16 KiloBytes/Sec ,Data ACQUIRED

is not valid. What is posibble cause . Data has specified pattern .And

i am storing data in buffer after collecting enough data i stores data

to hard disk.Data is corupted.
 

The Device responsible for transmitting the Data and the one receving should be Synchronised

Regards
dEVEN
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top