Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Waveguide Cutoff in HFSS

Status
Not open for further replies.
H

hosein_rabiee_g

Member level 2
Joined
May 9, 2010
Messages
53
Helped
8
Reputation
16
Reaction score
8
Trophy points
1,288
Location
IR
Activity points
1,550
Hi .
How can I express the waveguide cut off frequency in HFSS.
Rgds.
 

I'm not sure what do you mean ...

but If you are referring to how to demonstrate that a certain propagation mode has a certain cut-off frequency you have just to excite this mode and simulate it on the frequency range of interest.
 

simple, draw a piece of waveguide, do a full-band simulation, then you will see a "high-pass" response, which represents "cut-off"
 

What if you want an actual number, say for an optimization analysis?
 

You can you the prorogation constant, which is the im(gamma(portNumber:mode)). If you could be more specific as to what you are trying to optimize about the waveguide it would be helpful.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top