Tech_boy
Newbie level 5
Hi guys,
I'm new to this forum, but I was told that you guys are willing to help in a short time.
I am currently doing a project. This involves in mixing hot and cold water to obtain a pre-defined temperature at the output, which will be set by the user. I am not going to use instant heating / cooling.
I will be using the 8051 microcontroller and LM35 temperature sensors.
1. I would like to know if any of you has done a similar project or knows from where I can find help.
2. I will be needing a valve which opens bit by bit to let the required amount of water to pass, however I can find any. It must be aple to keep in the required position (for example, only 2/5 of it is open etc) .. Preferable, it works with a stepper motor so that I can easily program it using the 8051 and C language. Do you guys know from where I can buy one please?
Thanks,
Tech_boy
I'm new to this forum, but I was told that you guys are willing to help in a short time.
I am currently doing a project. This involves in mixing hot and cold water to obtain a pre-defined temperature at the output, which will be set by the user. I am not going to use instant heating / cooling.
I will be using the 8051 microcontroller and LM35 temperature sensors.
1. I would like to know if any of you has done a similar project or knows from where I can find help.
2. I will be needing a valve which opens bit by bit to let the required amount of water to pass, however I can find any. It must be aple to keep in the required position (for example, only 2/5 of it is open etc) .. Preferable, it works with a stepper motor so that I can easily program it using the 8051 and C language. Do you guys know from where I can buy one please?
Thanks,
Tech_boy