Goldseemon
Newbie level 3
Hello,
I'm totally new in FPGA field, so i hope i can get as much possible guidance here if possible...Thank you everyone for your time and support.
I am currently trying to process video using FPGA Board. It is just a simple mapping of pixels. my process will be something like:
Export a continuous video (taken using webcam), into FPGA, then FPGA will perform mapping of the video, such as, the pixel at coordinate say, (1,1), will be mapped into a new image at coordinate say, (99,1) for example. After finished mapping the pixels at all the coordinates, I will then import the new video back into computer.
( I already had all their corresponding coordinates to be mapped, and the new coordinate of the pixels..)
Can anyone guide me as to how can i do it using matlab and Xilinx ISE Project Navigator? (Or any recommended software?). How should i import the image into FPGA board? Using simulink / system generator? If so, how should i setup the connection between my board and my pc? And how can i import the image into the board after setting up the connections? Matlab code? Verilog? Or..? or i need some software to run it to establish the connections? After exporting the image into FPGA board, how can i process it? And How should the image be exported back to PC?
Sorry for all these questions, but i can't seem to find a proper detailed explanations on all these... The more i find, the more confused i get.
I hope someone out there is able to help me at least, on how or where to start...
Thank you very much.
For your information, i am using Xilinx Spartan-6 LX150T Development Kit.....
Regards,
Goldseemon
I'm totally new in FPGA field, so i hope i can get as much possible guidance here if possible...Thank you everyone for your time and support.
I am currently trying to process video using FPGA Board. It is just a simple mapping of pixels. my process will be something like:
Export a continuous video (taken using webcam), into FPGA, then FPGA will perform mapping of the video, such as, the pixel at coordinate say, (1,1), will be mapped into a new image at coordinate say, (99,1) for example. After finished mapping the pixels at all the coordinates, I will then import the new video back into computer.
( I already had all their corresponding coordinates to be mapped, and the new coordinate of the pixels..)
Can anyone guide me as to how can i do it using matlab and Xilinx ISE Project Navigator? (Or any recommended software?). How should i import the image into FPGA board? Using simulink / system generator? If so, how should i setup the connection between my board and my pc? And how can i import the image into the board after setting up the connections? Matlab code? Verilog? Or..? or i need some software to run it to establish the connections? After exporting the image into FPGA board, how can i process it? And How should the image be exported back to PC?
Sorry for all these questions, but i can't seem to find a proper detailed explanations on all these... The more i find, the more confused i get.
I hope someone out there is able to help me at least, on how or where to start...
Thank you very much.
For your information, i am using Xilinx Spartan-6 LX150T Development Kit.....
Regards,
Goldseemon