Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

VHDL all inputs/outputs at 2.5V

Status
Not open for further replies.
P

Pheetuz

Full Member level 3
Full Member level 3
Joined
Feb 12, 2010
Messages
162
Helped
21
Reputation
42
Reaction score
19
Trophy points
1,298
Location
Brighton
Activity points
2,835
Hi folks.

I have just loaded a program that I have written into a 22V10, the program built and simulated fine.

I have connected VCC and VSS to the device and then went to check the power was actually reaching the VCC pin, to my suprise I found that all the input/ ouput pins except VSS and VCC were at 2.5V-ish.

Does anyone have any ideas as to why this could be??

My friend has also loaded a similar code into a 16V8 to test it and found that all his inputs/outputs are at 5V.

Many thanks.

/Pete
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top