Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I design 8GHz 180 hybrid couple using PCB microstrip to generate differential input signal to test 8GHz divider by2 circuit as figure shown,But I have a question: Is the Port 3 of the coupler is terminated by 50ohm load ,open or short ?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.