Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Synopsys TetraMax ATPG B16-1 and B12-1 Error

Status
Not open for further replies.

ibtesam90

Newbie level 6
Newbie level 6
Joined
Jul 23, 2019
Messages
13
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
174
Dear All,
I am trying to generate test patterns for a test bench circuit "wb_conmax" by opencores. I have successfully generated the gate-level netlist. And I had successfully inserted the scan chain. However, I am unable to generate test patterns. It gives following error
for_eda_TetraMax_wb_conmax.PNG
The script I am using to generate is as follows:
Code:
read_netlist -library ../SAED90_EDK/SAED_EDK90nm/Digital_Standard_cell_Library/verilog/saed90nm.v
read_netlist report/wb_conmax_top_top_after_scan.v

run_build_model wb_conmax_top

add_slow_bidi -all
set_buses -external_z X

set_drc -allow_unstable_set_resets
set_drc -clock -dynamic -disturb_clock_grouping
set_drc -allow_unstable

run_drc report/wb_conmax_top_top_after_scan.spf

set_simulation -xclock_gives_xout

report_violation -all

set_faults -model stuck
add_faults -all
set_faults -fault_coverage -summary verbose -report uncollapsed
set_atpg -fill X

report_atpg_constraints
report_buses -all
report_clocks
report_pi_equivalences
report_settings

run_atpg -auto

write_patterns ./wb_conmax_full.stil -internal -format stil99 -replace 
exit
I unable to get any help on Solvnet or get any document on TestMax from Synopsys site.
Thanking in advance for you time and help.
Regards/
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top