Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Some problem when run EDA software

Status
Not open for further replies.

cloudliu

Junior Member level 3
Junior Member level 3
Joined
Jul 19, 2004
Messages
27
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
175
libstdc++-libc6.2-2.so.3 site:www.edaboard.com

My system is REHL3AS,and I installed TCAD and Laker on it.But after installed and ran,it's showed that message:
<command>:error while loading shared libraries:libcprt.so.t.(Or libstdc++-libc6.2-2.so.3 and so on) cannot open shared object file:No such file or directary.
Is there anybody has encounter such problem like me?Thank you!
 

run eda gmbh

I think you need to install the compat-glibc package for your RHEL system.
 

Thank you gliss.But could you tell me the detail where to download it please?And which version should I download?My hardware are Pm1.7+855PM.
 

Hi choudliu,

to over come the problem you need to install GTk2.....just give a google search 4 GTK2 you will find it N go tru the installation document which comes with the tool....tuts it...

BTW wut TCAD r u using r u in2 devices????can you share your license file??
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top