chethankp
Member level 4
Hi,
We have procured 8 THER200 and 8 VG400 sensors,
My sensor board can supply only maximum of 3.2v supply voltage , but these sensor datasheet says that it needs 3.3 to 20v DC, will these sensor will function properly at 3v ,. and these sensor needs only less than 800microA current so is there any simple way to get a voltage more than 3.3 volt for certain period(while reading the sensors )
I can provide only maxium of 3.2V as supply voltage ..
regards
chethan
We have procured 8 THER200 and 8 VG400 sensors,
My sensor board can supply only maximum of 3.2v supply voltage , but these sensor datasheet says that it needs 3.3 to 20v DC, will these sensor will function properly at 3v ,. and these sensor needs only less than 800microA current so is there any simple way to get a voltage more than 3.3 volt for certain period(while reading the sensors )
I can provide only maxium of 3.2V as supply voltage ..
regards
chethan