canopy
Newbie level 2
Fuse simulation
Hello everybody!
I'm trying to simulate fuse for 180nm process using CFD software.
Fuse is a piece of Al wire created with top metal and passivation opening above.
I apply power dissipation to it and calculate time-temperature chart.
The problem is that I can't determine the point when my fuse is blown up.
Any solutions on this?
Thanks in advance.
Hello everybody!
I'm trying to simulate fuse for 180nm process using CFD software.
Fuse is a piece of Al wire created with top metal and passivation opening above.
I apply power dissipation to it and calculate time-temperature chart.
The problem is that I can't determine the point when my fuse is blown up.
Any solutions on this?
Thanks in advance.