Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

shielding in orcad pcb designer standard v16.6

Status
Not open for further replies.

arbangalore

Newbie level 5
Newbie level 5
Joined
May 4, 2013
Messages
9
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Location
bangalore
Activity points
1,337
hi,

I have a RF line of 15mil width, i need to shield this line with a ground line and the spacing between the two should be 45mil.


how to do this in orcad?
 

Hi,
if you want to shield the RFline with ground (stitching via )add via and connect to the ground.can you post snapshot i can help more..
 

shield_route.jpg


thanks kapil,

I've attached a snapshot, i'm unable to get uniform spacing between the rf line & the shield over the route length.

let me knw if u need any other info.
 

Hi,
open the constraint manager--->spacing constraint -->make spacing cset and then set line to line spacing is 45mil. now it will work
 

but the spacing for differential routing is 10mil and the shield is 45..
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top