Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Screwdrivers question

Status
Not open for further replies.
Z

zoliky

Newbie level 1
Joined
Apr 6, 2010
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Arad
Activity points
1,288
Can I use these screwdrivers to open computer ATX cases, and motherboard screws ? : **broken link removed**

Are they quality products ? I never had proskit.
I would be grateful for any opinions. Thank you!
 

Hali Zoli,
Seems me that the grips are to short (for me with ca. 4-5cm shorter as wished) to have enough stability & force for driving out a fixer screw...
As kit is good one selected system, but a category smaller as I would buy for general PC mountings.
Greetings!
Karesz
 

I normally get those 'universal screwdrivers' with changeable bits (tips) for various use. Usually, this lets you get 100 different tools and the money only goes to producing ONE Handle, rather than 100 handles (grips) - so it's usually much better value and quality for money.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top