Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

SAW frequency to voltage converter ic

Status
Not open for further replies.
N

nafnaf

Junior Member level 1
Joined
Aug 21, 2012
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,388
is there an IC to convert the output frequency of surface acoustic wave to voltage which is 3khz~30ghz or should i make one using op amp ? any suggestion in this
much appreciated
 

surface acoustic wave
Click to expand...

I don't know for sure, but this sounds like it might be a job for a 'pressure zone' microphone. Radio Shack did (or does) market one of these (although it may not be very different from an ordinary mic).

3khz~30ghz
Click to expand...

The ratio is 10 billion to 1. It will not be easy to resolve the entire spread of such a large range. If you want a maximum of 10 V, your minimum shall be 1 uV.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top